Opticon LH2 Manuel d'utilisateur télécharger pdf (Page 31)

Chapter 3

Chapter

Chapter 4

Conguring the Imager

Since the operation of a LH2 imager is microprocessor controlled, it is possible to modify or

program its operation to match your specic application. Changes in parameter settings can

be changed or programmed in two ways:

(1) The rst method employs specially designed programming bar codes which instruct the

imager to modify specic parameters. You can scan any of the barcodes from Appendix A

to program the LH2.

(2) The imager can also be programmed by sending software instructions from the host PC

to the imager via the RS232 connection only for the commands that are available.

Programming Menus & Commands

Appendix A contains full instructions on how to congure the imager as well as a complete

listing of the host serial commands and programming bar codes that are available to

customize the imager for your application.

Default Settings

Default settings are indicated throughout the menus to follow.

To restore the “out-of-the-box” settings shown in the following table, use the Reset to

Factory defaults setting and Clear All Prex & Sufx barcode settings

RS-232 Interface Setting Defaults

Baud Rate 57600

Stop Bits 1

Data Bits 8

Parity None

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 101 102

Pas de commentaire

Opticon LH2 Manuel d'utilisateur Page 31